Maximum millage: 1.9036 mills


Maximum millage: 1.9036 mills


Date: July 14, 2010
by: Kurt Schultheis | City Editor


The looming threat of oil washing ashore, albeit not likely for Longboat, was a key factor in the commission’s decision to set the tax bar higher this year.

In an about-face from last year’s hard-line stance, the commission voted 5-2 at its Monday, July 12 regular meeting to establish a maximum millage rate of 1.9036 mills, at the suggestion of Town Manager Bruce St. Denis and Finance Director Tom Kelley.

The proposed maximum millage rate is 19% higher than last year’s maximum millage rate of 1.6 mills. Last July, the majority of the commission did support St. Denis’ suggestion of 1.6750 mills.

Commissioner David Brenner, who urged the commission to use some of the town’s $5 million reserve fund to pay for a $965,000 pension bill in fiscal year 2010-11 as recently as last month, changed his mind and supported the higher maximum millage rate, which fully funds the six-figure pension bill.

“I hope we don’t have to spend a dime to clean up oil from our shores, but, until that’s under our belts, I want the $5 million in reserves left intact until then,” Brenner said.

St. Denis informed the commission earlier in the evening it could cost $2 million for each pass (Longboat Pass and New Pass) to stop oil from getting in Sarasota Bay if the town chooses to go above and beyond the state-and-federal emergency oil-response plan.

The majority of the commission agreed with Brenner. Only Mayor George Spoll and Commissioner Phillip Younger did not vote in favor of the maximum millage rate selected.

Because the tax rate will not be officially decided until September, Commissioner Robert Siekmann pointed out that the commission still has time to set a tax rate that’s lower than the maximum rate selected.

“By late September, we may know if we will have any oil expenditures whatsoever and can decide if we want to use reserves if oil comes ashore or not,” Siekmann said.

Siekmann made the motion to set the maximum millage rate of 1.9036 mills, and Commissioner Hal Lenobel seconded the motion.

Siekmann, Lenobel, Brenner, Vice Mayor Jim Brown and Commissioner Lynn Larson voted for the maximum rate.

The commission had the option of setting the maximum millage rate as high as 2.0153 mills. Although the maximum millage rate can be reduced in later budget hearings, it now can’t be set any higher than 1.9036 mills.

For taxpayers, if the maximum millage is adopted in September, property owners sitting west of Gulf of Mexico Drive will see a tax-rate decrease, while property owners east of Gulf of Mexico Drive will see a tax-rate increase (see box below).

The reason?

The town already collected the taxes in fiscal year 2009-10 it needs to pay the final debt payment due in December 2010 for its latest beach renourishment project. And because beachside property owners pay 80% of the beach-project debt, they will get a one-year tax reprieve while bayside property owners who pay the other 20% of the debt will see a tax uptick this year.

But commissioners warned the reprieve would be short-lived because bond payments will come back in effect the following year for a new beach project to begin in November 2011.

“It (the tax rate) comes back with a vengeance the following year,” Spoll said, “there is no good news here.”
Spoll also expressed doubt that further budget reductions might happen.

“We accomplished that goal last year by forcing a lower (tax) rate than what was recommended by staff and putting pressure on staff to make other internal cuts,” Spoll said. “This year, that further pressure was not introduced.”

The recommended budget will be presented to the commission in early August, and the budget will be adopted on second reading at a special meeting at 5:01 p.m. Monday, Sept. 27.

Beachside vs. Bayside

The following table shows the effect of a maximum millage rate of 1.9036 mills on a range of Longboat Key home vales when compared to fiscal year 2009-10.

Beachside Resident
Home value Tax bill change
$250,000 ($48.70)
$500,000 ($97.40)
$750,000 ($146.10)
$1 million ($194.80)

Bayside Resident
Home value Tax bill change
$250,000 $66.55
$500,000 $133.10
$750,000 $199.65
$1 million $266.20

Contact Kurt Schultheis at

Login Register now

Currently 3 Responses

  • 1.
  • Watch them use this rate.
  • robert sewell
    Tue 20th Jul 2010
    at 5:32pm
  • 2.
  • Reduce the millage rate to below last year's rate. The oil issue is a non event and we have the reserves to cover any temporary damage should it ever happen. In any case, BP has pledged to reimburse any damages incurred. The millage increase is no skin off St. Denis' back since he doesn't live on Longboat Key. In his mind, why not pad the reserves--it's a safety valve for him as town manager. But it's a tax on residents. Here's my proposition: let those town employees who work at town hall, especially the unionized police and firemen, relinquish a portion of their salaries and pension plans to enhance the reserves in order to help the town and give something back to the town that has given them an inordinately generous pay and benefits package over the years. Either that or the town cuts back on employment and most certainly union benefits. Unionization is nothing other than legalized price fixing that would be a felony in private business. Hold the unions accountable. If those employees quit, there are gobs more people willing to take their places. Let the free market reign for goods, services and employment.
  • Milan Adrian
    Thu 15th Jul 2010
    at 8:32pm
  • 3.
  • We elected them, Tax and spend Democrats. The TOWN has 5 million in reserves why not cut the monies we give to the good for nothing Coastal Planing and Engineering consultants and keep the millage more or less where it has been.
  • George McFarland
    Wed 14th Jul 2010
    at 7:36am
Login below to post a comment or click register.
Account E-Mail
forgot password? click here
Speak Your Mind Below!


Subscribe to our eNewsletters
1970 Main Street, Sarasota, FL 34236 941-366-3468

Copyright 2015 The Observer Group Inc., All Rights Reserved